Electronic Weapons: Machine Vision Goes to War

Archives

January 22, 2024: Machine Vision is a manufacturing technology that first appeared in the 1980s, when high-speed cameras became available and were used to carry out detailed and rapid monitoring and adjustments to manufacturing operations. The technology continually improved as the Machine Vision equipment became more efficient as well as more compact and affordable. During 2023, Ukrainian weapons developers were able to install Machine Vision devices in armed UAVs (Unmanned Aerial Vehicles) using Machine Vision as their guidance system. This approach meant the attacker was immune to electronic jamming or the need to home in on the radar signals of an air defense system. Attack UAVs are seeking an image their Machine Vision guidance is programmed to find and attack. Machine Vision tech is compact and cheap enough to use in attack UAVs and the Ukrainians are doing that against the Russians, who haven’t come up with any countermeasures to the Machine Vision approach yet. The Russians will come up with some countermeasures, and they have been able to do that in most cases.

Before Machine Vision came along the most common guidance system for munitions was GPS or laser guidance. Projectiles equipped with either or both of these guidance systems can hit targets with greater precision than unguided projectiles and reduce enormously the number of projectiles required to destroy a target. GPS guidance is accurate enough to put a projectile within a few meters of the target while laser guidance can reliably hit individual vehicles, bunkers and even snipers in buildings. The laser guidance requires someone within a few thousand meters of the target to aim the laser at the target and keep it there for the laser guided shell to hit the reflected laser light. Later versions of these systems had a fire and forget feature that required the projectile to have a camera onboard to allow the guidance system to keep going after moving targets such as vehicles and individual soldiers.

Another advantage of laser guidance is that it is harder to jam than GPS. Some GPS jammers can disrupt GPS guidance within several thousand meters. Laser signal disruptors are more expensive and only provide protection for individual vehicles and similar size targets. GPS guidance adds over $40,000 to the cost of a projectile. This is economical because one guided projectile can destroy a target while it requires dozens or hundreds of unguided projectiles to do the job.

A less expensive way to produce a guided mortar or artillery shell was to use the American ATK guidance kit, which entered service with 155mm artillery shells in 2010 with American forces. A decade later a 120mm mortar version was introduced. ATK guidance systems were contained in a separate guidance system designed to replace the fuze that all artillery and mortar shells have and is screwed into the front of the shell. The ATK device is a larger fuze containing the precision guidance system, initially GPS, later laser and fins that move to put the artillery or 120mm mortar shell closer to the target. All you need to convert existing artillery or 120mm mortar shells to GPS guidance is the ATK or similar fuzes, which also handle the usual fuze functions, like when the explosives will be detonated. Artillery shells, for example, can be set to detonate over the target after hitting the ground or, for very large projectiles, after penetrating a certain distance into the ground.

To use the fuze type GPS systems, you place each fuze into a device that transfers the target GPS coordinates, then screw the fuze into the shell, and fire the shell. It would also be possible to program each fuze once it is screwed into the shell, via a metal probe that fits in a hole in the fuze, transfer the data, and signal that the transfer was accurately made. The GPS guided fuze can put the shell within 6-10 meters, and usually much less, of the coordinates entered.

Because of the GPS fuze, guided 120mm shells got a lot cheaper and easier to use. This is particularly crucial for 120mm mortars, which are used by units close to the front lines, where not a lot of ammo can be carried, and resupply is riskier since the enemy is so close. A guided 120mm shell means fewer shells getting fired to get the job done. Most vehicle mounted 120mm mortars carry about fifty 120mm shells and those vehicles can carry a dozen or more of the guidance fuzes to turn any of those fifty shells into a GPS or laser guided versions for use against targets that require only one or two shells rather than a barrage of a dozen or more shells landing over a wider area.

Unguided mortar shells cannot put the first round very close to the target, which means firing several rounds to adjust aim before one gets one on target. A guided mortar round is very useful in urban warfare, where a miss will often kill civilians. The 120mm mortar round has about 8 kg of explosives, compared to 10 kg in a 155mm shell. The smaller explosive charges reduce collateral damage to civilians. Normally, an unguided 120mm shell will land anywhere within a 136-meter circle on the first shot. All GPS guided rounds land within a ten-meter circle and laser guided shells land within a one-meter circle. The GPS guided mortar shells are popular with the troops as are the earlier GPS guided 155mm artillery shells, 227mm rockets and JDAM bombs.

Excalibur, the first effective and widely used GPS guided shell did not enter service until 2007 with the guidance system built into a 155mm shell. In 2011 Excalibur 1A-2 became available as an extended range version. Excalibur 1A-2 could hit targets with precision up to 40 kilometers away with the M777 howitzer or 60 kilometers or more with guns using longer barrels or rocket boosted shells. Excalibur 1A-2 was particularly useful in Afghanistan, where the older, 23 kilometer range shell was restricted by its short range. Guided rockets and shells have a longer effective range because unguided projectiles become less accurate the farther they go. With affordable and reliable projectiles, it was not possible to increase the range these weapons could be used. This was particularly true of mortars, which never had much range to begin with.

In 2013 Excalibur got some cheaper competition from the ATK M1156 Precision Guidance kit that is screwed into the front of the shell like a fuze would be. The ATK fuze cost less than half as much as an Excalibur shell. Initially Excalibur shells cost $100,000 each. That has since been reduced to less than $70,000 a shell as has the cost of ATK fuzes. Excalibur is more accurate than the ATK approach, but not enough to prevent ATK fuzes from outselling Excalibur.

ATK first introduced its GPS guidance fuze for 120mm mortar shells in 2011 and this proved very popular and successful with the troops. This was because mortars are considered very effective infantry weapons, and most nations equip their troops with 120mm mortars as well as larger numbers of smaller caliber 60mm or 82mm mortars that are carried by infantry. While light enough to move with the troops, mortar ammunition has to be carried as well. A 120mm mortar shell weighs about 16 kg, which is why 120mm mortars are transported in and often fired from a vehicle. Only a few dozen shells are carried with each vehicle and ammo resupply is more difficult for the infantry than for the larger, 105mm-155mm artillery that is usually ten kilometers or more behind the infantry. The 120mm mortar guided shell is much more important because far fewer, one instead of six or more, shells are needed to deal with a target. When fewer shells are needed the limited supply of shells carried with a 120mm mortar can deal with more targets.

Oddly enough the modern mortar did not show up until Britain developed it in 1915, during World War I. This was in response to troops requiring some kind of artillery they could use from the trenches and carry with them when they advanced. At that time artillery was horse drawn and troops transmitted target information via telephone lines. Although these telephone wires were designed to lie on the ground and be deployed or repaired quickly, in combat the lines were frequently cut by enemy artillery fire. Thus, the need for portable artillery support, which the lightweight British mortar provided. These infantry mortars were widely adopted and improved after World War I. The first large American mortar was a 107mm model based on the British four-inch 102mm mortar. The 120mm mortar was invented in France during the 1930s, and widely copied and used ever since.

The original 120mm mortar was too heavy, at 150-200kg for the troops to carry long distances, but it was lighter than regular artillery and as effective as the 105mm howitzers which provided most of the firepower during World War II. Some 120mm mortars were mounted on wheels and could be pulled by horses or troops. In Western armies the 120mm and 107mm mortars were often carried in light trucks or jeeps and set up next to the vehicle for firing. Some of these heavy mortars were mounted and fired from armored personnel carriers, which were first used during World War II.

The U.S. did not have a 120mm mortar during World War II and only had a 107mm model that was designed just for delivering chemical shells. Since chemical weapons were not used during World War II, with a few minor exceptions, the 107mm mortars didn't have much to do except deliver smoke shells, which some considered a chemical weapon, even though they provided concealment for friendly troops rather than casualties among the enemy. By the end of World War II, the 107mm mortar was firing high-explosive shells most of the time.

By 1944, it was recognized that the M2 4.2 inch/107mm mortars were useful as artillery and they were used as such, even though they had a range of only 3-4 kilometers. Each chemical battalion contained 32 mortars, and these were assigned to corps, which controlled two or more divisions, each with three regiments or brigades. This was quite different from the practice in other nations, where regiments and brigades were given 120mm mortars. One benefit of their past mission was that the battalions were equipped with white phosphorus/WP shells. The WP shell created a lot of smoke, but the burning phosphorus caused nasty casualties. The Germans made noises about illegal use of chemical weapons when they realized what WP could do, but this did not result in the use of chemical weapons in retaliation. Nor were the Germans able to use many WP shells themselves because of raw material shortages.

As the war went on, it became the American practice to assign one mortar company, with eight 107mm mortars, to an infantry battalion. Not all infantry battalions got mortars, preference being given to units involved in attacks. An improved 107mm mortar, the M30, was developed after World War II and widely exported. Many nations still use it, and the Americans did not adopt the 120mm mortar until 1991 when the Israeli Soltam was selected to replace the 107mm models. Israel, like most other nations, adopted 120mm mortars and Israel soon became a pioneer in developing new 120mm mortars, fire control systems and guided shells.

 

X

ad

Help Keep Us From Drying Up

We need your help! Our subscription base has slowly been dwindling.

Each month we count on your contributions. You can support us in the following ways:

  1. Make sure you spread the word about us. Two ways to do that are to like us on Facebook and follow us on Twitter.
  2. Subscribe to our daily newsletter. We’ll send the news to your email box, and you don’t have to come to the site unless you want to read columns or see photos.
  3. You can contribute to the health of StrategyPage.
Subscribe   Contribute   Close