Morale: Finding Hidden Flaws

Archives

October 9, 2008:  One reason for the lower American casualties in Iraq and Afghanistan (about a third of the rate suffered in Vietnam) was the introduction of ceramic plates, for protective vests,  that can stop a rifle bullet. The down side is that these plates are brittle. While they are built to take a lot of the battlefield rough treatment, they are subject to suffering invisible damage (hairline cracks that cannot be seen). These damaged plates may shatter and not completely stop a rifle bullet. This happens very rarely, but often enough to make some of the troops nervous. To deal with this problem, the army has developed an x-ray machine that can examine these plates (at the rate of 240 an hour) to find the plates with hairline cracks, and take them out of service. The procedure is for troops taking their combat leave (army troops in Iraq or Afghanistan gets two weeks leave during their one year tour), being issued new plates. The old ones, which have suffered about six months of service, are x-rayed, and the ones that pass are put back into service. The troops appreciate this kind of attention. A second of these x-ray machines (which cost about a million dollars each) will go to Afghanistan next year.

The basic "Level 3" SAPI plates are 10x12 inches, weigh 4.6 pounds each and cost about $400. A lighter weight (3.3 pounds) plate costs $750. The older Level 4 plates, weighing about 6.4 pounds each, could stop armor piercing bullets, but the new ESAPI weighs less and have the same stopping power. ESAPI is more expensive, at $600 a plate. There are also smaller plates that can be worn on the side.

SAPI are made of boron carbide ceramic with a spectra shield backing. This combination causes bullets to fragment and slow down before getting through the plate. Occasionally, some fragments will get through, but these are stopped by the layers of Kevlar that make up the flak jackets. The success of the plates, and the frequent attacks on U.S. troops in Iraq has led the U.S. Army to try and get enough plates for all troops in the combat zone, not just those in infantry units. This is more of a morale issue than anything else, as non-infantry troops are most frequently exposed to bombs and RPGs. The fragments from these weapons can be stopped by the "flack jackets" without the plates. But morale is important, so the army hustled early on to get enough SAPI plates for everyone. The ceramic plates require a manufacturing process that uses, and produces, a lot of toxic chemicals, much of the production has moved to China.

The Germans developed the first modern protective vests during World War I. These weighed about 20 pounds, restricted movement and were mainly used by troops who stayed put a lot (like machine-gunners.) During World War II, the U.S. developed a similar "flak jacket" for bomber crews. While not bullet proof, they did offer protection from exploding German anti-aircraft shells ("flak"), which caused most of the wounds for bomber crews. Again, these jackets were too heavy and bulky for the infantry, although these used layers of the new "synthetic silk", nylon, for added protection. At the end of World War II, the army had developed a 12 pound vest, using aluminum plates and nylon fabric. It was still bulky and restricted movement, but was a lot lighter. During the Korean war, an eight pound protective vest, using layers of nylon and a nylon type material (Doron), was provided starting in 1952. While not bullet proof, it was able to stop two thirds of fragments (which caused 75 percent of wounds) and some 20 percent of bullets (which caused 25 percent of wounds). Wound injuries to the torso were also reduced by two thirds. And those fragments and bullets that did penetrate did a third less damage. These T-52 vests cost about $280 (in current dollars). Improved versions of the T-52 were used with success in Vietnam, although these things were very hot in tropical climates. Often troops did not wear them if they knew they would be moving around a lot. The current protective vests, with SAPI plates front and back, cost about $16,000 each.

In the early 1970s, Kevlar vests were produced. Kevlar was a much stronger material than Doron and provided more protection. Although the Doron and Kevlar vests were not called "bullet proof", they could stop many pistol rounds, and even rifle rounds that were ricochets or had been fired a long distance. The tougher Kevlar fiber and better layout of the vest reduced casualties to the torso by over 70 percent (versus troops without the vest.) But the troops wearing a vest were still vulnerable to high velocity bullets (from AK-47s, M-16s and 7.62mm machine-guns). Being "bullet-proof" was important in a different way than having all that protection from fragments. The biggest danger from bullets was when you were attacking, when the enemy could actually see you, and shoot at you. This is the scariest part of being an infantryman. It's bad enough when you're in a foxhole or behind a wall getting shelled. At least you have some protection, and the older, fragment proof, protective vests were much appreciated in these situations. But when you were out in the open, being a little bit bullet proof makes a big difference to morale and motivation.

By the late 1980s, it was possible to make truly bullet proof vests using metallic inserts. But the inserts were heavy and so were the vests (about 25 pounds). Great for SWAT teams, but not much use for the infantry. But in the 1990s, additional research produced lighter, bullet proof, ceramic materials. By 1999 the U.S. Army began distributing a 16 pound "Interceptor" vest that provided fragment and bullet protection. This, plus the 3.3 pound Kevlar helmet (available since the 1980s), gives the infantry the best combination of protection and mobility. And just in time. Since the end of the Cold War, more of the situations U.S. infantry find themselves in involve lightly armed irregulars who rely more on bullets than bombs. The bullet proof vest eliminates most of the damage done by the 30 percent of wounds that occur in the trunk (of which about 40 percent tend to be fatal without a vest). The Kevlar helmet is also virtually bulletproof, but it doesn't cover all of the head (the face and part of the neck is still exposed). Even so, the reduction in deaths is significant. Some 15-20 percent of all wounds are in the head, and about 45 percent of them are fatal without a helmet. The Kevlar helmet reduces the deaths by at least half, and reduces many wounds to the status of bumps, sprains and headaches. Half the wounds occur in the arms and legs, but only 5-10 percent of these are fatal and that won't change any time soon. Thus since Vietnam, improved body armor has reduced casualties by more than half. The protective vests used in Vietnam and late in the Korean war reduced casualties by about 25 percent since World War II, so the risk of getting killed or wounded has been cut in half since World War II because of improved body armor. Much better medical care (especially rapid evacuation of casualties by helicopter) has helped reduce the ratio of dead to wounded from 3:1 during World War II to 5:1 today.

The Interceptor vest was an improvement in other ways. It was easier to wear, and was cooler in hot climates because you could more easily adjust it to let some air circulate. You could also hang gear from the vest, making it more a piece of clothing. It's still hot to wear the vest in hot weather, but if you're expecting a firefight, it's easier to make the decision to wear the vest. You know it will stop bullets. U.S. troops who have fought in Afghanistan, and hit with rifle bullets that would have penetrated earlier vests, are already spreading the word throughout the ground combat community.

 

X

ad

Help Keep Us From Drying Up

We need your help! Our subscription base has slowly been dwindling.

Each month we count on your contributions. You can support us in the following ways:

  1. Make sure you spread the word about us. Two ways to do that are to like us on Facebook and follow us on Twitter.
  2. Subscribe to our daily newsletter. We’ll send the news to your email box, and you don’t have to come to the site unless you want to read columns or see photos.
  3. You can contribute to the health of StrategyPage.
Subscribe   Contribute   Close